16 May 2022

Tribology - Materials, Surfaces & Interfaces, Vol. 16, No. 2, out now

Alloy dry sliding wear, tribological evaluations of a spark plasma sintered Mg–Ni composite, and top compression ring power loss in engines are examined.

slide
© Jelleke Vanooteghem/Unsplash

This issue contains the following articles, which are available to members via My IOM3.

Study of dry sliding wear behaviour of Ti-48Al-2Nb-2Cr alloy

Keyan Enayati & Fatemehsadat Sayyedan

Pages: 91-97

DOI: 10.1080/17515831.2021.1881876

High-temperature tribological investigation of APS and HVOF sprayed NiCrBSiFe coatings on SS 316L

Sanjay W. Rukhande, W. S. Rathod & Digvijay Bhosale

Pages: 98-109

DOI: 10.1080/17515831.2021.1898887

Tribological evaluations of spark plasma sintered Mg–Ni composite

Ogunlakin Nasirudeen Olalekan, M. Abdul Samad, Syed Fida Hassan & Muhammad Mohamed Ibrahim Elhady

Pages: 110-118

DOI: 10.1080/17515831.2021.1898898

Micro-abrasive wear study of a low-temperature plasma nitrided Inconel 625 superalloy

Luis Bernardo Varela, Michell F. C. Ordoñez, Carlos Eduardo Pinedo & Andre Paulo Tschiptschin

Pages: 119-129

DOI: 10.1080/17515831.2021.1898899

Investigation of the top compression ring power loss and energy consumption for different engine conditions

Anastasios Zavos & Pantelis G. Nikolakopoulos

Pages: 130-142

DOI: 10.1080/17515831.2021.1907682

Fretting fatigue behaviour of Ti–6Al–4V in contact with Alloy 718

S. Srivathsan & S. Ganesh Sundara Raman

Pages: 143-152

DOI: 10.1080/17515831.2021.1930343

Tribological behavior of hybrid aluminum self-lubricating composites under dry sliding conditions at elevated temperature

Pranav Dev Srivyas & M.S. Charoo

Pages: 153-167

DOI: 10.1080/17515831.2021.1931771

Effect of heat treatment on the wet abrasion resistance of WC-10Co4Cr coatings deposited onto stainless steel by HVOF

Milena Gallego, Stefany Carolina Chávez, Jhonattan de la Roche & Alejandro Toro

Pages: 168-176

DOI: 10.1080/17515831.2021.1938869

Ultrasonic technique for measurement of oil-film thickness in metal cold rolling

G. J. Adeyemi, R. S. Dwyer-Joyce, J. T. Stephen & A. Adebayo

Pages: 177-186

DOI: 10.1080/17515831.2021.1944549